Boots CS-1000 Manual de usuario descargar pdf (Pagina 47)

100

101

Notes

_____________________________________________________________

The call server is configured through

both the command line interface (CLI)

as well as the Element Manager (EM).

The command line is based on

“Overlays” or “Loads” and to interact

with the system you need to be in the

correct “Load” (LD) or “Overlay”.

To login type “LOGI” (Not case

sensitive) at the prompt, and either add

the username you wish to use on the

same line or hit enter for the USERID

prompt. Once the Username is input the

system will then request a password.

Once logged in to the CLI you change

“Overlays” by typing LD and the number

of the overlay you require. You must exit

an overlay before you can enter another

and this is done by typing ****.

There are a few lesser known

commands that can be very helpful

shown on the right. These allow you to

use a limited set of online help and to

look up error codes that appear without

exiting the overlay.

LON & LOF allow you to backspace in

the command line !!

CS 1000 Rel 7.5 16/04/2013

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 399 400

Boots CS-1000 Manual de usuario Pagina 47

Comentarios a estos manuales